diff --git a/bindings/input/touchscreen/STMicroelectronics.txt b/bindings/input/touchscreen/STMicroelectronics.txt
new file mode 100644
index 00000000..77993927
--- /dev/null
+++ b/bindings/input/touchscreen/STMicroelectronics.txt
@@ -0,0 +1,54 @@
+STMicroelectronics touch controller
+
+The STMicroelectronics controller is connected to host processor
+via i2c. The controller generates interrupts when the
+user touches the panel. The host controller is expected
+to read the touch coordinates over i2c and pass the coordinates
+to the rest of the system.
+
+Required properties:
+
+ - compatible		: should be "st,fts".
+ - reg			: i2c slave address of the device.
+ - interrupt-parent	: parent of interrupt.
+ - interrupts		: touch sample interrupt to indicate presense or release
+				of fingers on the panel.
+ - vdd-supply		: Power supply needed to power up the device.
+ - vcc-supply		: Power source required to power up i2c bus.
+ - st,irq-gpio		: irq gpio which is to provide interrupts to host,
+				same as "interrupts" node. It will also
+				contain active low or active high information.
+ - st,reset-gpio	: reset gpio to control the reset of chip.
+ - pinctrl-names	: This should be defined if a target uses pinctrl framework.
+			See "pinctrl" in Documentation/devicetree/bindings/pinctrl/msm-pinctrl.txt.
+			Specify the names of the configs that pinctrl can install in driver.
+			Following are the pinctrl configs that can be installed:
+			"pmx_ts_active" : Active configuration of pins, this should specify active
+			config defined in pin groups of interrupt and reset gpio.
+			"pmx_ts_suspend" : Disabled configuration of pins, this should specify sleep
+			config defined in pin groups of interrupt and reset gpio.
+			"pmx_ts_release" : Release configuration of pins, this should specify
+			release config defined in pin groups of interrupt and reset gpio.
+ - st,regulator_avdd	: name of Power supply needed to power up the device.
+ - st,regulator_dvdd	: name of Power source required to power up i2c bus.
+Optional properties:
+
+
+Example:
+	i2c@78b9000 { /* BLSP1 QUP5 */
+		st_fts@49 {
+			compatible = "st,fts";
+			reg = <0x49>;
+			interrupt-parent = <&msm_gpio>;
+			interrupts = <13 0x2008>;
+			vdd-supply = <&pm8916_l17>;
+			vcc-supply = <&pm8916_l6>;
+			pinctrl-names = "pmx_ts_active","pmx_ts_suspend";
+			pinctrl-0 = <&ts_int_active &ts_reset_active>;
+			pinctrl-1 = <&ts_int_suspend &ts_reset_suspend>;
+			st,irq-gpio = <&msm_gpio 13 0x00000001>;
+			st,reset-gpio = <&msm_gpio 12 0x0>;
+			st,regulator_dvdd = "vdd";
+			st,regulator_avdd = "avdd";
+		};
+	};