ARM: dts: qcom: add PM7550BA PMIC devices

Add SPMI slave device for PM7550BA, and some of its peripheral
devices.

Change-Id: I95ba6fa7d454e44ec10f4a3d5dd775828147513d

qcom/pm7550ba.dtsi

@@ -0,0 +1,87 @@
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+
+&spmi_bus {
+	#address-cells = <2>;
+	#size-cells = <0>;
+	interrupt-controller;
+	#interrupt-cells = <4>;
+
+	qcom,pm7550ba@7 {
+		compatible = "qcom,spmi-pmic";
+		reg = <7 SPMI_USID>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		pm7550ba_tz: qcom,temp-alarm@a00 {
+			compatible = "qcom,spmi-temp-alarm";
+			reg = <0xa00>;
+			interrupts = <0x7 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+			#thermal-sensor-cells = <0>;
+		};
+
+		pm7550ba_sdam_1: sdam@7000 {
+			compatible = "qcom,spmi-sdam";
+			reg = <0x7000>;
+		};
+
+		pm7550ba_sdam_2: sdam@7100 {
+			compatible = "qcom,spmi-sdam";
+			reg = <0x7100>;
+		};
+
+		pm7550ba_sdam_3: sdam@7200 {
+			compatible = "qcom,spmi-sdam";
+			reg = <0x7200>;
+		};
+
+		pm7550ba_sdam_4: sdam@7300 {
+			compatible = "qcom,spmi-sdam";
+			reg = <0x7300>;
+		};
+
+		pm7550ba_gpios: pinctrl@8800 {
+			compatible = "qcom,pm7550ba-gpio";
+			reg = <0x8800>;
+			gpio-controller;
+			#gpio-cells = <2>;
+			interrupt-controller;
+			#interrupt-cells = <2>;
+		};
+
+		pm7550ba_eusb2_repeater: qcom,eusb2-repeater@fd00 {
+			compatible = "qcom,pmic-eusb2-repeater";
+			reg = <0xfd00>;
+			status = "disabled";
+		};
+	};
+};
+
+&thermal_zones {
+	pm7550ba_temp_alarm: pm7550ba_tz {
+		polling-delay-passive = <100>;
+		polling-delay = <0>;
+		thermal-governor = "step_wise";
+		thermal-sensors = <&pm7550ba_tz>;
+
+		trips {
+			pm7550ba_trip0: trip0 {
+				temperature = <95000>;
+				hysteresis = <0>;
+				type = "passive";
+			};
+
+			pm7550ba_trip1: trip1 {
+				temperature = <115000>;
+				hysteresis = <0>;
+				type = "critical";
+			};
+
+			pm7550ba_trip2: trip2 {
+				temperature = <145000>;
+				hysteresis = <0>;
+				type = "critical";
+			};
+		};
+	};
+};