ARM: dts: msm: add touch driver nodes for Kalama RCM

Kalama RCM uses I2C for touch. Change disables the SPI serial engine
node and enables the touch drivers to use I2C bus for RCM target.

Change-Id: Id9acf1aaaf37ff1d76eda13fdec84dee44a9db3b

qcom/kalama-rcm.dtsi

@@ -1 +1,54 @@
 #include "kalama-cdp.dtsi"
+
+&qupv3_se4_spi {
+	status = "disabled";
+};
+
+&qupv3_se4_i2c {
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	status = "ok";
+	qcom,i2c-touch-active = "atmel,maxtouch";
+
+	goodix-berlin@5d {
+		compatible = "goodix,gt9916";
+		reg = <0x5d>;
+		interrupt-parent = <&tlmm>;
+		interrupts = <25 0x2008>;
+		goodix,reset-gpio = <&tlmm 24 0x00>;
+		goodix,irq-gpio = <&tlmm 25 0x2008>;
+		goodix,irq-flags = <2>;
+		goodix,panel-max-x = <1080>;
+		goodix,panel-max-y = <2400>;
+		goodix,panel-max-w = <255>;
+		goodix,panel-max-p = <4096>;
+		invert_xy;
+		goodix,firmware-name = "goodix_firmware_i2c.bin";
+		goodix,config-name = "goodix_cfg_group_i2c.bin";
+		goodix,avdd-name = "avdd";
+		goodix,iovdd-name = "iovdd";
+		avdd-supply = <&L14B>;
+		iovdd-supply = <&L12B>;
+	};
+
+	atmel_mxt_ts@4a {
+		compatible = "atmel,maxtouch";
+		reg = <0x4a>;
+		interrupt-parent = <&tlmm>;
+		interrupts = <25 0x2008>;
+		avdd-supply = <&L14B>;
+		vdd-supply = <&L12B>;
+		pinctrl-names = "pmx_ts_active", "pmx_ts_suspend";
+		pinctrl-0 = <&ts_active>;
+		pinctrl-1 = <&ts_int_suspend &ts_reset_suspend>;
+
+		atmel,xy_switch;
+		atmel,inverty;
+		atmel,invertx;
+		reset-gpios = <&tlmm 24 0x00>;
+		irq-gpios = <&tlmm 25 0x2008>;
+		atmel,panel-coords = <0 0 479 799>;
+		atmel,display-coords = <0 0 339 729>;
+	};
+};