Add the carveout memory regions and common cma pool for ravelin,
These regions are used by various clients in system.
Change-Id: I0b02c018831737c7758051259dc74eabc5bc89a1
Skip cmb_msr configuration for south and dlct2-cmb tpdm.
Add spmi tgu to support spmi trace.
Change wcss tpdm to a dummy source.
Change some cti type to extended.
Change-Id: I3ec543494133eee0c6ff6d5a8c8c90ea2ca28360
Add graph nodes representing the USB connector and its remote
endpoints to the UCSI device and the USB controller respectively.
Add 'usb-role-switch' properties to the DWC3 devices and update
its dual-role mode to 'otg'.
This is in order to describe a connection between the pmic_glink
and the DWC3 device to allow the former to notify the USB controller
when to start up in USB host or peripheral mode.
Change-Id: I2672c643579beb72d061f12566e03f3771176fd3
This is the lowest ddr bandwidth that puts CX at a corner
high enough such that GMU can run at 550 Mhz. This is to
get better GMU performance at no extra power cost.
Change-Id: I4ac794b91139073c1914f8e8e39a29db03a3f09d
Disable eMMC for parrot platform as its disabling ufs shared
regulator during probe leading to ufs probe failure upon
hibern8 exit.
Change-Id: I520e1604723dcdb5cecd20ca2571d0cdc8fcecf9
Currently the DTSI change for parrot has wrong SE number programmed
into GSI config for QUPV3_1. Hence rectify it correcting the SE
number.
Change-Id: Id714b2c524e6e2d4d1301e08ad9968c2e3ac4a89
Add device-tree bindings documentation describing the properties
for the Helios remoteproc driver.
Change-Id: Ic5c07f623721946759996ae1b722f23f8d9ca1ec
LDO24B has its voltage set to 2.4V (min voltage) by regulator framework
as part of regulator registration if the initial voltage is not set.
This regulator will only be voted for enabling/disabling
conditions by UFS, so fix this by removing the min/max voltage values
for this regulator.
Change-Id: I13f82e919e3e46f2e1a6cc0905f69f11c6fb2b2d
GPU GX GDSC is only required to be disabled from HLOS to initiate
GMU recovery in case of any failure. Add support for the same on
PARROT platform.
Change-Id: I76a1382fef304197b3347091a1711208e6414a48
Currenly usb3phy_portselect_default is defined outside tlmm block,
which gives an issue while getting phandle for ssphy. Because of this
dwc3-msm probe is failing. To fix that move the definition inside
tlmm block.
Change-Id: I3e8ca39e733c6cc7532302b586027f7c4ed97a38
Add stub regulator support for PM6XXX and pm8010 on ravelin
to allow the regulator clients to vote on them.
Change-Id: Id8867a56c23e970cfa7fb5a224c5891c938731cc
